TAC I/NET Converters

Up one level

The TAC I/Net 2000 protocol driver is available as a client and a server. The client can poll MR devices on a MR LAN. The server can emulate MR devices on a MR LAN. The client and server drivers both support quick polling. Quick polling refers to the ability to only report changed data whereas normal polling reports all data irrespective of changes. The drivers support the basic TAC I/Net data points. Data may be collected and stored in any combinations of input and output points making it easier to move data around. Only the specified TAC I/Net type data will be stored.

Convert

We have module solutions which allow integration directly into TAC I/NET products as well as the stand alone solutions shown bottom right.

Range of Conversion Solutions

Depending on project requirements select from units with varying resources. and multi port devices. OEM and embedded solutions too.

FS20 Series	1x RS232/485	1x Ethernet	1x Lonworks
FS25 Series	2x RS232/485	1x Ethernet
FS30 Series	2x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support:eg Profibus, DeviceNet etc Hot Standby Support
FS40 Series	10x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support: eg DH+, MB+, Profibus, DeviceNet etc Hot Standby Support
SlotServer	1x RS232/485	1x Ethernet	1x Lonworks	For Rockwell ControlLogix 5600

Lonworks and Fieldbus are options not proviced on base models.

Range of Solutions - Single and multiport - in chassis 5600

Find your protocol

We have a huge list of protocols.

Web

Building automation

Other Categories

Fire Alarm Panels
HVAC Systems
Custom
Transportation and Fuel
Intercom / Siren
Lighting
Genset, gas, instrument, misc
Full List
... Over 110 other protocols and counting

Industial

OPC for Scada / HMI
Modbus (Full family of protocols)
- RTU and Jbus
- TCP/IP
- MB+
- Daniels
Rockwell (Full family of protocols)
GE-Fanuc (Full family of protocols)
- SNP
- SNPx
- EGD
- SRTP
- GE Mark IV
- GE TLC

Industial

Block Diagram

FS30 series shown for purposes of illustration. Capability depends on hardware, firmware and configuration.

Chipkin Automation Systems

1. Experience working with TAC data conversion. We have sold and installed many systems connecting TAC I/net to foreign building management systems and devices.

2. We are system integration specialists. We have worked with most of the Building Automation Systems before.

3. We provide a free CAS BACnet explorer when you integrate to a system using BACnet. This software tool, developed by us, helps your technicians prove and test the interface. This option will save you $600 and give you confidence should the dreaded ‘integration finger pointing’ occur.