Notifier Integration

Up one level

There are two ways we can help you with Omron FINS. Firstly we can help you connect foreign systems to your Omron PLC such as fire alarm systems, gas sensors, HVAC equipment, building automation systems etc. This way you can use your PLC's to control and monitor these devices without having to implement a hard wired solution. Secondly we can help your control or building automation system monitor and control data in an Omron PLC. In both modes our gateway can act as a client and server or combination. Omron data can be read and written.

Convert

We have module solutions which allow integration directly into Notifier products as well as the stand alone solutions shown bottom right.

Range of Conversion Solutions

Depending on project requirements select from units with varying resources. and multi port devices. OEM and embedded solutions too.

FS20 Series	1x RS232/485	1x Ethernet	1x Lonworks
FS25 Series	2x RS232/485	1x Ethernet
FS30 Series	2x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support:eg Profibus, DeviceNet etc Hot Standby Support
FS40 Series	10x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support: eg DH+, MB+, Profibus, DeviceNet etc Hot Standby Support
SlotServer	1x RS232/485	1x Ethernet	1x Lonworks	For Rockwell ControlLogix 5600

Lonworks and Fieldbus are options not proviced on base models.

Range of Solutions - Single and multiport - in chassis 5600

Find your protocol

We have a huge list of protocols.

Web

Building automation

Other Categories

Fire Alarm Panels
HVAC Systems
Custom
Transportation and Fuel
Intercom / Siren
Lighting
Genset, gas, instrument, misc
Full List
... Over 110 other protocols and counting

Industial

OPC for Scada / HMI
Modbus (Full family of protocols)
- RTU and Jbus
- TCP/IP
- MB+
- Daniels
Rockwell (Full family of protocols)
GE-Fanuc (Full family of protocols)
- SNP
- SNPx
- EGD
- SRTP
- GE Mark IV
- GE TLC

Industial

Block Diagram

FS30 series shown for purposes of illustration. Capability depends on hardware, firmware and configuration.

Chipkin Automation and Rapid Engineering

1. Many of the Notifier drivers for FieldServer were developed by Chipkin Automation Systems. We are experts to source code level.

2. Experience working with Notifier Systems. We have sold and installed many systems connecting Notifier panels to foreign building management systems and devices.

3. We are system integration specialists. We have worked with most of the Building Automation Systems before.

4. We provide a free CAS BACnet explorer when you integrate to a system using BACnet. This software tool, developed by us, helps your technicians prove and test the interface. This option will save you $600 and give you confidence should the dreaded ‘integration finger pointing' occur.