GE Fanuc Data Conversion

Up one level

There are two ways we can help you with Ge Fanuc PLC's and drives. Firstly we can help you connect foreign systems to your GE equipment and PLC. We can help you connect systems fire alarm systems, gas sensors, HVAC equipment, building automation systems etc. This way you can use your PLC's to control and monitor these devices without having to implement a hard wired solution. Secondly we can help your control or building automation system monitor and control data in an GE Fanuc PLC. In both modes our gateway can act as a client and server or combination. GE data can be read and written.

Convert

We have module solutions which allow integration directly into GE Fanuc products as well as the stand alone solutions shown bottom right.

Range of Conversion Solutions

Depending on project requirements select from units with varying resources. and multi port devices. OEM and embedded solutions too.

FS20 Series	1x RS232/485	1x Ethernet	1x Lonworks
FS25 Series	2x RS232/485	1x Ethernet
FS30 Series	2x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support:eg Profibus, DeviceNet etc Hot Standby Support
FS40 Series	10x RS232 and 2x RS485	2x Ethernet	1x Lonworks	FieldBus Support: eg DH+, MB+, Profibus, DeviceNet etc Hot Standby Support
SlotServer	1x RS232/485	1x Ethernet	1x Lonworks	For Rockwell ControlLogix 5600

Lonworks and Fieldbus are options not proviced on base models.

Range of Solutions - Single and multiport - in chassis 5600

Find your protocol

We have a huge list of protocols.

Web

Building automation

Other Categories

Fire Alarm Panels
HVAC Systems
Custom
Transportation and Fuel
Intercom / Siren
Lighting
Genset, gas, instrument, misc
Full List
... Over 110 other protocols and counting

Industial

OPC for Scada / HMI
Modbus (Full family of protocols)
- RTU and Jbus
- TCP/IP
- MB+
- Daniels
Rockwell (Full family of protocols)
GE-Fanuc (Full family of protocols)
- SNP
- SNPx
- EGD
- SRTP
- GE Mark IV
- GE TLC

Industial

Block Diagram

FS30 series shown for purposes of illustration. Capability depends on hardware, firmware and configuration.

Chipkin Automation and GE Fanuc

These drivers were developed by Chipkin Automation Systems for FST. We know the GE protocols to source code level and provide 2nd tier support to FST. Get expert support and configuration from day 1 with Chipkin Automation Systems.