Federal Signal Ultravoice Siren Data Conversion
Up one level
If you need remote monitoring and control of your Federal Signal Ultravoice Electronic Siren Controller then we can help provide solutions. Our solution provides the ability to monitor the controller and report the status as well as allowing you to control the activation of commands. Thus, you can integrate the monitoring and control into your site wide automation system.
Convert
We have module solutions which allow integration directly into Federal Signal Ultravoice Siren as well as the stand alone solutions shown bottom right.
Range of Conversion Solutions
Depending on project requirements select from units with varying resources. and multi port devices. OEM and embedded solutions too.
| FS20 Series | 1x RS232/485 | 1x Ethernet | 1x Lonworks | |
| FS25 Series |
2x RS232/485 | 1x Ethernet |
||
| FS30 Series |
2x RS232 and 2x RS485 | 2x Ethernet | 1x Lonworks | FieldBus Support:eg Profibus, DeviceNet etc Hot Standby Support |
| FS40 Series |
10x RS232 and 2x RS485 | 2x Ethernet | 1x Lonworks | FieldBus Support: eg DH+, MB+, Profibus, DeviceNet etc Hot Standby Support |
| SlotServer |
1x RS232/485 |
1x Ethernet | 1x Lonworks | For Rockwell ControlLogix 5600 |
Lonworks and Fieldbus are options not proviced on base models.
Find your protocol
We have a huge list of protocols.
| Web
Building automation Other Categories
|
Industial
|
Industial |
Block Diagram
FS30 series shown for purposes of illustration. Capability depends on hardware, firmware and configuration.
Chipkin Automation and Federal Signal
This driver was developed by CAS – Get expert support from day 1 with CAS.
CAS worked with the vendor and TAC North West to test the driver.
Data Sheets and Manuals
Need Help
Federal Signal Web Site: www.federalsignal.com
Need more info ? Call or email us.
Metasys® as used in this document is a trademark of Johnson Controls, Inc.